Getting Fiber cable ready for termination or Splicing

by

Bentley JamesI recently watched my co-worker disassembling a computer only using one tool. Was it the right tool for the work? It depends. It had been the tool he had… it worked, however, there is surely more than a single tool out there that could have made the chore easier with fusion splicer.

This situation is surely the one that many fiber optic installers know all too well. Being a gentle reminder, just how many of you have used your Splicer’s Tool Package (cable blade/scissors) to eliminate jacketing or even slit a buffer pipe and then use the scissors to hack away at the Kevlar? Did you nick the wine glass? Did you inadvertently trim through the wine glass and have to start over?

Appropriately splicing and terminating Fiber cable requires special tools and techniques. Training is important and there are many excellent resources of training available. Usually do not mix your electronic tools with your fibers tools. Utilize the right tool for the work! Being experienced in fiber work can be progressively necessary as the value of data transmitting speeds, fibers to the house and fibre to the idea deployments keep on increasing.

Many factors set fiber installations other than traditional electrical projects. Fiber optic glass is very delicate; it’s nominal outer diameter is 125um. The slightest scratch, symbol or even speck of mud will impact the transmitting of light, degrading the indication. Basic safety is important because you will work with goblet that can sliver into your skin layer without having to be seen by the eye. Transmission level lasers are incredibly dangerous, and require that protecting eyewear is crucial. This industry has generally been dealing with voice and data grade circuits that may tolerate some interruption or decelerate of signal. The individual speaking would do it again themselves, or the info would retransmit. Today we are dealing with IPTV indicators and customers who’ll not tolerate pixelization, or momentary locking of the picture. All the situations talked about are cause for the client to consider another carrier. Each situation might have been averted if proper attention was presented with to the techniques used while preparing, installing, and maintaining fiber optic cables and OTDR.

That being said, we will review basic fiber preparation? Jacket Strippers are used to remove the 1.6 – 3.0mm PVC exterior coat on simplex and duplex fibre wires. Serrated Kevlar Cutters will cut and reduce the kevlar strength member directly beneath the jacket and Buffer Strippers will take away the acrylate (buffer) finish from the bare glass. A protective plastic coating is put on the bare dietary fiber after the pulling pro cess, but prior to spooling. The most frequent finish is a UV-cured acrylate, which is applied in two tiers, producing a nominal outside size of 250um for the layered fiber.

Reliable, stable and automatic fusion splicer for anytime and anywhere usage. Rely on Techwin for the top performing test and measurement instruments!

Tech-Win China is your most reliable choice for Fusion splicer, Fiber cable,

OTDR

solutions. Visit us now and gather more information about our services. Call us now for more details.

Article Source:

eArticlesOnline.com}